• Settings Pike Superior X-tail competition mode:
    The settings on this page is ONLY for advanced pilots. For sports flying look here
    Hook apx 104mm from leading edge (see picture).
    V-tail: 112mm - Xtail: CG: 117mm from leading edge.
    CG will change with lead forward. CG for speed apx 115mm
    This is normal     but might have to be adjusted for the task flown
    Throws are based on Jo Grini's throws. Please make own adjustments.
    Recommending strong and fast elevator servo. New digital Volz MicroMaxx XP is very good.
    Read also the     NEW page: Setup
Pike Superior 31/9-05 CG 117mm Hook : apx: 104mm from leading edge
Surface/acting as Mode Direction Travel  
Aileron/Aileron start up 17mm all measured at wing tip, 40% expo
  speed up 17mm  
  Thermal up 17mm  
  start down 0mm No longer than start camber
  speed down 11mm  
  thermal down 7mm  
Flap/Aileron start up 8mm all measured at wing root
  speed up 8mm  
  thermal up 8mm  
  start down 0mm No longer than start camber
  speed down 10mm  
  thermal down 6mm  
Aileron/Crow All up 7mm at tip
Flap/Crow All down 80degr at root (apx 35/65mm)
Speed flap (flap) speed up -2mm Equal along all trailing edge 
Speed flap (ail) speed up apx-1,5mm Measured at tip
Start flap (flap) start down 12mm  
Start flap (ail) start down apx 9mm 2mm less than flap (because of smaller aileron)
Thermal flap (flap) thermal down 0-5mm Sweet 2mm
Thermal flap (ail) thermal down 0-..mm 0,5-1mm less than flap (because of smaller aileron)
X-tail measuring: (picture) All neutral meassured at top steel rod elevator
Elevator neutral 89mm Measured on top of steel rod and below tail. See picture. This apx. starting points!!!
Elevator Thermal   88,5mm All deppending on camber used. Meassured at 3mm camber
Elevator start 88mm Hook at apx 104mm. (2mm behind middle position)
Elevator zoom   88,5 This is in zoom going down/up....
Elevator crow 86/85,5mm measured at half/full crow with aileron only 7mm up
Elevator All up/down 94/84mm Servo arm might need to be long. 82mm down elevator must be possible when crow is activated. Minum servo is 4kg/0,18s on 60degrees
Rudder All left/right apx 30mm apx 50% combi-switch while launching