• Settings Pike Brio competition (X-tail) :
    Hook apx 104mm from leading edge (see picture), CG: 118mm from leading edge
    CG will change with lead. Adjust with spacers. CG with 500g 115mm. CG with 1000g 114-115mm
    Throws are based on Jo Grini's throws. Please make own adjustments.
    Read also the     NEW page: Setup
Pike Brio 31/9-05 CG 118mm Hook : apx: 104mm from leading edge
Surface/acting as Mode Direction Travel  
Aileron/Aileron start up 16mm all measured at wing tip, 40% expo
  speed up 16mm  
  Thermal up 16mm  
  start down 8mm  
  speed down 8mm  
  thermal down 6mm  
Flap/Aileron start up 7mm all measured at wing root
  speed up 7mm  
  thermal up 7mm  
  start down 6mm  
  speed down 6mm  
  thermal down 6mm  
Aileron/Crow All up 9mm at tip
Flap/Crow All down 90degr at root
Elevator/crow mix V-tail All down 2/4mm measurement at half/full crow at ele tip. 
Elevator All up 6mm all measured at tip, 40% expo
Elevator Speed up 6mm all max movement -9/+10 (ele/rud togheter)
Elevator All down 5mm  
Elevator Speed down 5mm  
Rudder Speed up 7mm 40% expo. no combi switch other than in start and F3F
Rudder thermal up 7mm 40% expo. no combi switch other than in start and F3F
Rudder Speed down 5mm 40% expo. no combi switch other than in start and F3F
Rudder thermal down 5mm 40% expo. no combi switch other than in start and F3F
Speed flap (flap) speed up 0-2mm ? Equal along all trailing edge 
Speed flap (ail) speed up 0-1,5mm Measured at tip
Speed flap (ele) speed down 0-0,5mm   
Start flap (flap) start down 14mm Equal along all trailing edge
Start flap (ail) start down apx 8mm  
Start flap (ele) start down 0,5mm Can be -0,5mm depending on hook and CG
Thermal flap (flap) thermal down 0-6mm Equal along all trailing edge
Thermal flap (ail) thermal down 0-..mm  
X-tail: (picture)
Elevator neutral 89,5mm Measured on top of steel rod and below tail. See picture
Elevator start/speed 88,5mm If used in start the hook needs to be apx 103mm
Elevator crow 86/85mm measured at half/full crow with aileron only 7mm up
Elevator All up/down 94/85mm
(82 w/crow)		 Servo arm might need to be long if not fast servo is used.
Rudder All left/right apx 30mm apx 10mm combi-switch while launching